2012 Ford Mustang GT
8
Builds
33
Knowledge
36
Parts
50
Tools
Builds
2012 Mustang GT Strut Swap | Unexpected Issues!
2/26/2026
Finally solved this 2012 mustang GT idle issue!
4/27/2026
Fixing Misfire Issues: 2012 Mustang GT Coil Pack Swap
2/26/2026
2012 Mustang GT Fuel Injector Cleaning
3/28/2026
2012 Mustang GT Spark Plugs BURIED in Oil - Here's What Happened
2/26/2026
PT1 - 2012 coyote timing cover gasket reseal
9/5/2026
Reassembling The Timing Cover On A 2012 Mustang GT
9/11/2026
PT2 - 2012 Mustang GT Timing Cover gasket replacement
9/8/2026
Knowledge
Can I use a pour-in fuel additive instead of an inline cleaning kit?How do I know if the timing cover gasket is properly sealed?How long will a timing cover gasket reseal on a Coyote take?Can I reuse the old gasket or bolts?What should I check after reassembling the timing cover?How long will this job take for a DIYer?What causes oil to fill the spark plug wells?Can I drive the car if the plugs are covered in oil?What torque should I use for the coil mounting bolt?What fluids do I need to buy for this job?What torque specs should I use for the timing cover bolts?Can I reuse the old springs with new strut cartridges?What if the strut-to-knuckle bolts are seized?How difficult is this job for a DIYer?How do I know if the PCV grommet is bad?How often should I clean the fuel injectors?Do I need to remove the engine or major mounts to access the timing cover?Do I need to replace the spark plug when replacing a coil?Do I need to replace the ignition coils too?Is this an expensive repair?Do I have to remove the injectors to clean them?Is special tooling required for a 2012 Mustang GT?Should I use a gasket, RTV, or both when reinstalling the timing cover?Is a spring compressor required?Do I need special tools to replace the timing cover gasket?Do I need to replace the crankshaft front seal when reassembling the timing cover?Can I reuse the old gasket and seals?How do I know which coil is bad?What usually causes a rough idle on a 2012 Mustang GT?What symptoms indicate my injectors need cleaning?Can I just clean the throttle body to fix the idle?How long will the repair take?Can I clear the code and drive without replacing the coil?
Parts (34)
Tools (43)