What fluids do I need to buy for this job?
Documented on the 2012 Ford Mustang GT build
Published September 5, 2026
You may need some engine coolant to top up or refill the system after draining.
Full Answer
You may need some engine coolant to top up or refill the system after draining. If any oil was contaminated or removed during the job, plan for a small oil top-up or filter change—check levels afterward.
Documented In This Build
Related Knowledge
How long will a timing cover gasket reseal on a Coyote take?Do I need to remove the engine or major mounts to access the timing cover?Can I reuse the old gasket and seals?How do I know if the PCV grommet is bad?What torque should I use for the coil mounting bolt?What causes oil to fill the spark plug wells?Can I drive the car if the plugs are covered in oil?How often should I clean the fuel injectors?
Related Parts
Timing Cover Gasket Kit
Fel-Pro (or OEM equivalent)$75
Front Crankshaft Seal (harmonic balancer seal)
National / OEM$20
RTV Gasket Maker (high-temp silicone)
Permatex$6
Timing Cover Bolt / Fastener Kit (replacement bolts)
ARP / OEM equivalent$15
Harmonic Balancer / Crank Pulley Bolt (replacement)
OEM$8
Engine Coolant (pre-mixed or concentrate to make ~2 gal)
Peak / Motorcraft$30
Related Tools
Socket set (including deep 10mm–24mm)
Torque wrench (inch-lb and ft-lb capable)
Seal installer / driver
Breaker bar and impact gun (optional)
Harmonic balancer / crank pulley puller
Gasket scraper / plastic razor
Jack and jack stands or engine support
Shop rags, brake cleaner, and degreaser
