What safety precautions should I take during testing?
Documented on the Hitch Winch Pulley Build Finale build
Published July 14, 2026
Wear eye and hand protection, keep bystanders clear and out of the pull line, use rated recovery points and shackles, perform incremental pulls, and inspect equipment between tests.
Full Answer
Wear eye and hand protection, keep bystanders clear and out of the pull line, use rated recovery points and shackles, perform incremental pulls, and inspect equipment between tests. Avoid standing in line with the cable or pulley under load.
Documented In This Build
Related Knowledge
How do I know the pulley and hardware are strong enough?Can this be permanently welded to the vehicle?What torque should I use on the blade bolt?What maintenance is required to keep the runtime optimal?What were the most critical problems found on the test drive?Can these issues be fixed cheaply or will it cost a lot?How do I know if the leak is from the oil pump or the tank?Can I fix the leak without buying a new pump?
Related Parts
Pulley sheave (snatch block style)
$45
Sealed bearings (for pulley)
$15
Winch (12V electric) used for testing
$250
Roller fairlead
$60
Mounting hardware (grade 8 bolts, washers, nuts)
$12
Shackle (5/8" bow/clevis)
$25
Winch rope / cable (section)
$30
Finish / protective coating (powder coat or paint)
$40
Stainless hardware set (misc)
$8
Fabricated hitch bracket (steel)
$120
Related Tools
Arc/MIG Welder
Bench vise / clamps
Protective gear (gloves, helmet, eye protection)
Drill and set of drill bits
Socket/ratchet and impact wrench
Measuring tape and square
Torque wrench
Angle grinder with cutoff and flap discs
Related Videos
Quick Cub Cadet Z2 Ultima 54 inch review
Project Front Loader Pt 3: Starting to assemble the bucket!
Poulan Pro PP19A42 Maintenance: Spindle Removal and Blade Sharpening
Soothing Lawn Mowing June 19th 2026, Cub Cadet Z2 54
First project vehicle and how I started it on fire
Project Front Loader: Pt1 testing our new stick welder