How do I prevent the hose from kinking or tangling?
Documented on the Cheap Hose Reel Build Using Scrap Wood build
Published March 28, 2026
Use an appropriate hose swivel or guide at the hub to let the hose feed off without twisting, keep the drum diameter large enough for the hose diameter, and wind the hose neatly in coils under light tension.
Documented In This Build
Related Knowledge
How much hose will this reel hold?Can I mount this reel outdoors?Can I motorize the reel later?What torque should I use on the blade bolt?What maintenance is required to keep the runtime optimal?What were the most critical problems found on the test drive?Can these issues be fixed cheaply or will it cost a lot?How do I know if the leak is from the oil pump or the tank?
Related Parts
2x4 lumber (frame/spacers/axle supports)
$6
Dowel or metal pipe (shaft)
$8
Ball bearings (or sleeve/bushing alternative)
$10
Bolts, nuts and washers (mounting hardware)
$5
Hose swivel / hose connector (optional)
$12
Exterior wood screws
$3
Exterior paint / wood sealer
$8
End caps / rubber bumpers (optional)
$2
Scrap plywood (side plates / drum faces)
$10
Related Tools
Wrenches / socket set
Clamps
Circular saw
Jigsaw
Drill / impact driver
Hole saw or spade bit
Sander or sandpaper
Tape measure and combination square
Paintbrush or roller
Related Videos
Quick Cub Cadet Z2 Ultima 54 inch review
Project Front Loader Pt 3: Starting to assemble the bucket!
Poulan Pro PP19A42 Maintenance: Spindle Removal and Blade Sharpening
Soothing Lawn Mowing June 19th 2026, Cub Cadet Z2 54
First project vehicle and how I started it on fire
Project Front Loader: Pt1 testing our new stick welder