What type of hydraulic cylinders and hoses are required?
Documented on the Project Front Loader Pt 5: Assembling the frame build
Published April 27, 2026
Use cylinders rated for the load and stroke required by your geometry (the video uses two lift cylinders).
Full Answer
Use cylinders rated for the load and stroke required by your geometry (the video uses two lift cylinders). Hoses should be pressure-rated for the hydraulic system and sized to match the fittings; allow service loops to prevent binding during travel.
Documented In This Build
Related Knowledge
What materials thickness should I use for the bucket and frame?How are pivot points protected against wear?How much will this cost to build?What torque should I use on the blade bolt?What maintenance is required to keep the runtime optimal?What were the most critical problems found on the test drive?Can these issues be fixed cheaply or will it cost a lot?How do I know if the leak is from the oil pump or the tank?
Related Parts
MIG welding wire and shielding gas (consumables)
$40
Primer and paint
$40
Grease fittings (zerk fittings) and grease
$10
Fasteners (grade 8 bolts, nuts, washers)
$30
Steel square tubing (various sizes for frame and arms)
$120
Steel plate for bucket (3/16"–1/4" sheet)
$180
Hydraulic cylinder (front loader lift) - quantity 2
$600
Pivot pins and bronze/steel bushings
$60
Hydraulic hoses and fittings
$150
Gusset plates, angle iron and reinforcement brackets
$50
Related Tools
MIG welder
Drill or drill press
Measuring tools (tape, square, angle finder)
Angle grinder with cutting and grinding discs
Chop saw / metal cutoff saw
Clamps and angle clamps
Hammer and mallet
Related Videos
Quick Cub Cadet Z2 Ultima 54 inch review
Project Front Loader Pt 3: Starting to assemble the bucket!
Poulan Pro PP19A42 Maintenance: Spindle Removal and Blade Sharpening
Soothing Lawn Mowing June 19th 2026, Cub Cadet Z2 54
First project vehicle and how I started it on fire
Project Front Loader: Pt1 testing our new stick welder