How do I dial in the correct amperage for the electrode?
Documented on the Project Front Loader: Pt2 Continuing to feel out build
Published March 28, 2026
Weld several short beads on scrap metal and adjust amperage until the arc is stable: too low leads to stubbing and poor fusion, too high causes excessive spatter and burn-through.
Full Answer
Weld several short beads on scrap metal and adjust amperage until the arc is stable: too low leads to stubbing and poor fusion, too high causes excessive spatter and burn-through. Watch the bead shape and sound to refine settings.
Documented In This Build
Related Knowledge
What electrode types should I use when learning on a stick welder?How can I reduce warping when welding loader components?What safety gear is essential for stick welding?How do I clean slag and finish my welds?What torque should I use on the blade bolt?What maintenance is required to keep the runtime optimal?What were the most critical problems found on the test drive?Can these issues be fixed cheaply or will it cost a lot?
Related Parts
Cellulose stick electrodes (e.g., 6011) - 5 lb
$15
Low-hydrogen stick electrodes (e.g., 7018) - 5 lb
$25
Metal stock (steel plate/tube) - raw material
$10
Grinding discs / flap discs (pack)
$15
Primer / touch-up paint (small can)
$10
Related Tools
Angle grinder
Stick welder (SMAW)
Auto-darkening welding helmet
Chipping hammer and wire brush
C-clamps / welding clamps
Square and tape measure
Workbench / welding table
Related Videos
Quick Cub Cadet Z2 Ultima 54 inch review
Project Front Loader Pt 3: Starting to assemble the bucket!
Poulan Pro PP19A42 Maintenance: Spindle Removal and Blade Sharpening
Soothing Lawn Mowing June 19th 2026, Cub Cadet Z2 54
First project vehicle and how I started it on fire
Project Front Loader: Pt1 testing our new stick welder