Do I need a special tool to check pushrod length?
Documented on the Chevrolet Small Block 350 (sbc 350) build
Published April 27, 2026
While not strictly required, an adjustable pushrod checking tool or pushrod checker makes verifying length and rocker geometry far easier and more accurate than trial-and-error with fixed-length rods.
Documented In This Build
Related Knowledge
How do I know when the pushrod length is correct?How tight should rocker nuts be?Can I reuse old pushrods?How important is degreeing the cam?What torque sequence and values should I use for SBC heads?How do I set lifter preload or hydraulic lash?What should I do to prepare the engine for first start and break-in?What torque should I use on the crankshaft bolt?
Related Parts
Pushrods (set of 16)
$120
Assembly lube
$10
Pushrod guideplates / clips
$25
Related Tools
Torque wrench
Ratchet and socket set
Adjustable pushrod checking tool / pushrod checker
Feeler gauge / valve lash gauge (if checking lash)
Magnet pickup / shop rag
Related Videos
Small Block Chevy 350 Build Pt. 6 | This Is How It's Actually Supposed To Be Done
Small Block Chevy 350 Build Pt.3 | Filing rings and checking main clearances
Small Block Chevy 350 Build Pt.5 | Continued frustrations with rod clearances
Small Block Chevy 350 Build Pt. 11 | Installing the intake manifold and figuring out sbc nuisances
Small Block Chevy 350 Build Pt. 7 | Checking Crank Clearance and installing the rods.
Small Block Chevy 350 Build Pt. 8 | Installing Camshaft and timing components