Can I start fabricating the loader after this video?
Documented on the Project Front Loader: Pt1 testing our new stick build
Published March 28, 2026
This video covers testing and practice plus initial tacks and mock-up; full fabrication and structural welding are planned for later parts, so ensure consistent practice and settings before proceeding to final welds.
Documented In This Build
Related Knowledge
What amperage should I set on a stick welder?What torque should I use on the blade bolt?What maintenance is required to keep the runtime optimal?What were the most critical problems found on the test drive?Can these issues be fixed cheaply or will it cost a lot?How do I know if the leak is from the oil pump or the tank?Can I fix the leak without buying a new pump?How much does it typically cost to repair an oil leak on a Ryobi 40V chainsaw?
Related Parts
E7018 welding electrodes (box)
$30
Electrode holder (stinger)
$25
Ground clamp and cable
$30
Steel rectangular tubing and plate (scrap/test stock)
$150
Cutting/grinding discs (pack)
$15
Welding helmet (auto-darkening)
$80
Welding gloves
$20
Related Tools
Angle grinder
Tape measure and combination square
Stick welder (SMAW / arc welder)
Chipping hammer and wire brush
C-clamps / welding clamps
Metal cutting saw / bandsaw (optional)
Related Videos
Quick Cub Cadet Z2 Ultima 54 inch review
Project Front Loader Pt 3: Starting to assemble the bucket!
Poulan Pro PP19A42 Maintenance: Spindle Removal and Blade Sharpening
Soothing Lawn Mowing June 19th 2026, Cub Cadet Z2 54
First project vehicle and how I started it on fire
Project Front Loader Pt 6: Linear actuator and bucket install on lawn mower