What else is left to finish the build after installing the intake?
Documented on the Small Block Chevy 350 Build Pt. 10 | Checking out build
Published April 27, 2026
Remaining tasks usually include installing the carburetor or throttle body, connecting fuel and vacuum lines, hooking up coolant crossovers/thermostat housing, installing sensors and accessories, checking clearances, and prepping for initial startup and break-in procedures.
Documented In This Build
Related Knowledge
What torque spec should I use for intake bolts?How important is degreeing the cam?What torque sequence and values should I use for SBC heads?How do I set lifter preload or hydraulic lash?What should I do to prepare the engine for first start and break-in?What torque should I use on the crankshaft bolt?How do you test an oil pump on the bench?What is the acceptable rod bearing clearance for a Small Block Chevy 350?
Related Parts
Intake manifold gasket set
$30
Carburetor or throttle-body (depending on setup)
$250
Intake bolt kit / hardware
$20
RTV / sealant (for thermostat housing or specific sealing points)
$6
Intake manifold (Small Block Chevy 350 fitment)
$350
Related Tools
Torque wrench
Ratchet and socket set (SAE/metric as needed)
Gasket scraper / razor blade
Shop rags / solvent
Shop light / inspection light
Related Videos
This 65 Mustang Keeps Throwing Curveballs
Small Block Chevy 350 Build Pt. 6 | This Is How It's Actually Supposed To Be Done
Small Block Chevy 350 Build Pt.3 | Filing rings and checking main clearances
Cub Cadet Ultima Z2 54 5 hour +some maintenance video
Small Block Chevy 350 Build Pt.5 | Continued frustrations with rod clearances
Small Block Chevy 350 Build Pt. 11 | Installing the intake manifold and figuring out sbc nuisances