Can I reuse the old valve cover gaskets?
Documented on the Ford Coyote (gen 1 5.0l) build
Published September 10, 2026
It's not recommended.
Full Answer
It's not recommended. Old rubber gaskets become compressed and brittle; replacing them with new gaskets ensures a proper seal and prevents future leaks.
Documented In This Build
Related Knowledge
What torque specs should I use for the valve cover bolts?How difficult is the timing cover portion of this job?Do I need to remove the intake manifold to remove the valve covers?Will I have to drop the coolant or remove the water pump to replace the timing cover gasket?How important is degreeing the cam?What torque sequence and values should I use for SBC heads?How do I set lifter preload or hydraulic lash?What should I do to prepare the engine for first start and break-in?
Related Parts
Timing cover gasket
$45
Valve cover gasket set (left & right)
$75
PCV grommets / valve grommets
$20
RTV silicone (sensor-safe)
$8
Misc hardware / replacement bolts (if needed)
$15
Related Tools
Torque wrench
Socket set and ratchet
Harmonic balancer / crank pulley puller
Gasket scraper / plastic razor blade
Pry bar / trim tools
Shop rags and brake cleaner / solvent
Breaker bar / impact gun (optional)
Related Videos
Small Block Chevy 350 Build Pt. 10 | Checking out a new intake and talking about things left to do
This 65 Mustang Keeps Throwing Curveballs
Small Block Chevy 350 Build Pt. 6 | This Is How It's Actually Supposed To Be Done
Small Block Chevy 350 Build Pt.3 | Filing rings and checking main clearances
Cub Cadet Ultima Z2 54 5 hour +some maintenance video
Small Block Chevy 350 Build Pt.5 | Continued frustrations with rod clearances