How do I route wires through the tailgate hinge without chafing?
Documented on the 2017 Chevrolet Silverado 1500 build
Published May 27, 2026
Use the factory rubber grommet/boot or install a dedicated rubber pass-through grommet.
Full Answer
Use the factory rubber grommet/boot or install a dedicated rubber pass-through grommet. Route wires so they have slack through the hinge movement and secure them with zip ties to prevent rubbing against metal edges.
Documented In This Build
Related Knowledge
Can I tap the reverse light power instead of running a dedicated trigger wire?What size fuse should I use for the amp power wire?How do I bleed air from the cooling system after installing the pump?What are common causes of premature water pump failure?Do I need to replace the thermostat or serpentine belt when replacing the water pump?How long does a water pump replacement take?What coolant should I use for a 2017 Silverado 1500?What safety steps should I take before starting?
Related Parts
Universal tailgate reverse camera (waterproof)
$60
50 ft RCA video extension / camera harness
$25
4 AWG amp power wire kit (includes ground wire)
$60
Inline fuse holder and 100A fuse
$15
Grommet / rubber pass-through (tailgate hinge area)
$5
Ring terminals and butt connectors kit (insulated)
$10
Zip ties and wire loom
$5
Heat shrink tubing / solder sleeve
$5
Add-a-circuit or wire tap for reverse light trigger
$8
Related Tools
Socket set and ratchet (metric)generic
Wire stripper/crimpergeneric
Soldering iron (optional)generic
Trim panel pry toolsgeneric
Multimeter / test lightgeneric
Fish tape / flexible pull wiregeneric
Drill and drill bits (or step bit)generic
