How much will repairs cost?
Documented on the Project Front Loader: Pushed to the breaking build
Published May 27, 2026
Parts in this build are estimated around $1,030 total (parts-only).
Full Answer
Parts in this build are estimated around $1,030 total (parts-only). Actual costs vary by vehicle, brand choice, and whether both sides are replaced; labor (if using a shop) will add to the final cost.
Documented In This Build
Related Knowledge
How do I know if my front-end components are 'pushed to the breaking point'?Can I replace control arms and tie rods at home without special tools?How do I set up the suspension for my weight?Can I reuse the old springs with new strut cartridges?What if the strut-to-knuckle bolts are seized?How difficult is this job for a DIYer?Will this Mandatory Suspension Seat fit my Cub Cadet Z2 54 without modifications?Do I need to disconnect any wiring when removing the old seat?
Related Parts
Lower control arm (pair)
MOOG (typical aftermarket)$240
Outer tie rod ends (pair)
ACDelco / aftermarket (typical)$80
Front strut assembly (pair)
KYB / Monroe (typical)$400
Wheel bearing/hub assembly (front)
Timken / SKF (typical)$150
Front brake rotors (pair)
Centric / Raybestos (typical)$90
Front brake pads (set)
Hawk / EBC / OEM (typical)$40
Sway bar end links (pair)
Moog / Dorman (typical)$30
Related Tools
Torque wrench
Floor jack
Jack stands
Breaker bar
Impact wrench (air or electric)
Ball joint separator / pickle fork
Hammer / pry bar
